Dye Sublimation Printer, if you want to clean the printer's nozzles, you need to use distilled water, a lint-free rag and a plate. The specific process is as follows:
1. Soak the rag with distilled water.
2. Gently wash (do not rub) the nozzle at the bottom of the nozzle with a damp cloth for 3 to 5 times.
Repeat the cleaning process for all the nozzles to be cleaned in the sublimation printer. A clean rag should be used for each nozzle to avoid mixing the colors of the nozzle ink. Test the nozzle to see if the nozzle is blocked. If there is still a blockage, the distilled water can be heated slightly and placed in a small amount on the plate. When the nozzle is placed on the plate, the water surface should not be higher than the bottom 2CM because the water may leak behind the chip.
Stand the nozzle of digital inkjet printer upright in warm water. Wait for 30 seconds, then dry the nozzle with a paper towel before testing.
Each nozzle should be cleaned with clean water. Alternatively, the nozzle can be cleaned with an ultrasonic cleaner.
To clean the chip, you need alcohol and cotton swabs or a lint-free scrub. The specific operation method is as follows:
1. Turn off the power of the photo machine.
2. Soak the cloth or cotton cloth with the wine.
3. Gently scrub the chip behind the nozzle to remove dirt or ink.
Repeat this process for each nozzle of the digital sublimation printer to ensure that each nozzle is scrubbed with a clean portion of the cloth or a clean cotton swab. Take the nozzle out of the small frame and gently scrub the contact strip on the frame with a clean wet cotton swab or a damp cotton cloth. After cleaning, install the nozzles to ensure they are properly seated. The cleaning process for the entire printer nozzle is complete.
No comments:
Post a Comment